Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 96

4. Remove all the installed hot-swap HDDs and dummy trays (if any) from the HDD cage, then disconnect
all the cables from the backplane. See "Removing a hot-swap drive" on page 78.
5. Lift the release latch and slide the HDD cage out of the chassis.
Figure 54. Removing the HDD cage
6. Open the plugger that secures the backplane, carefully lift the backplane a little bit up to release it from
the HDD cage, and then remove the backplane.
Figure 55. Removing the backplane
7. If you are instructed to return the old backplane, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
Installing the backplane
To install the backplane, do the following:
Watch the procedure. A video of the installation process is available at:
84
ThinkServer TS460 User Guide and Hardware Maintenance Manual
1
1
2
2