Figure 48. Opening the handle of a dummy tray
4. Pull the handle and carefully slide the drive or the dummy tray out of the chassis. Save the removed
dummy tray in case that you later remove the drive and need a dummy tray to cover the drive bay.
Figure 49. Removing the drive or dummy tray
5. Install a new drive or a dummy tray to cover the drive bay. See "Installing a hot-swap drive" on page 79.
6. If you are instructed to return the old drive, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
7. Close and lock the front door.
Installing a hot-swap drive
To install or replace a hot-swap drive, do the following:
Watch the procedure. A video of the installation process is available at:
• Youtube:
https://youtu.be/UuSadg5Eiaw
• Youku:
http://v.youku.com/v_show/id_XMjYwODcwOTU5Mg==.html?&f=49135033&from=y1.2
1. Use the front door key to unlock the front door (available on some models), and then open the front
door.
2. Remove a drive or a dummy tray. See "Removing a hot-swap drive" on page 78.
1
Chapter 5
.
79
Replacing hardware