Front Panel Board Assembly - Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual

Figure 60. Removing the intrusion switch
Installing the intrusion switch
To install the intrusion switch, do the following:
Watch the procedure. A video of the installation process is available at:
• Youtube:
https://youtu.be/MgGoDXHecEc
• Youku:
http://v.youku.com/v_show/id_XMjYwODcxMjM5Mg==.html?&f=49135033&from=y1.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. If needed, remove the old intrusion switch. See "Removing the intrusion switch" on page 88.
3. Insert the cable of the new intrusion switch and then the tab on the intrusion switch frame into the
corresponding hole in the chassis. Then, push the intrusion switch in until it is securely seated.
Figure 61. Installing the intrusion switch
4. Connect the cable of the new intrusion switch to the branch connector on the front panel connector 2
that is connected to the system board. See "System board components" on page 31.

Front panel board assembly

• "Removing the front panel board assembly" on page 89
• "Installing the front panel board assembly" on page 90
Note: The front panel board assembly is sensitive to ESD. Ensure that you read and understand "Handling
static-sensitive devices" on page 54 first and carefully perform the operation.
Removing the front panel board assembly
To remove the front panel board assembly, do the following:
Watch the procedure. A video of the removing process is available at:
• Youtube: https://youtu.be/ZSx3Br7Ae9Y
.
Chapter 5 Replacing hardware
89