Intrusion Switch - Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual

Figure 59. Installing the non-hot-swap power supply
4. Connect cables to the new non-hot-swap power supply. Then, properly route the cables and secure the
cables with the cable clips and ties in the chassis.

Intrusion switch

This topic applies only to server models that have the intrusion switch installed.
• "Removing the intrusion switch" on page 88
• "Installing the intrusion switch" on page 89
Removing the intrusion switch
To remove the intrusion switch, do the following:
Watch the procedure. A video of the removing process is available at:
• Youtube: https://youtu.be/PXqjlsuariE
• Youku: http://v.youku.com/v_show/id_XMjYwODc1ODQzMg==.html?&f=49135033&from=y1.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. Locate the intrusion switch. Then, disconnect the intrusion switch cable from the branch connector on
the front panel connector 2.
3. Press the two tabs on the intrusion switch towards each other and carefully pull out the intrusion switch
at the same time to remove it from the frame.
88
ThinkServer TS460 User Guide and Hardware Maintenance Manual
2
1
0
M
G M
T
1
2
1
3
4
2
ID