Table of Contents
Advertisement
2. Pull the handle to slide the drive out of the chassis.
Removing a 3.5-inch hot-swap drive
To reinstall, reverse the steps above.
Special Note: Install the hot-swap drives into the available bays in the order numbered in the diagrams below. Install dummy
trays in all vacant hot-swap drive bays.
Order of installation for 3.5-inch hot-swap drives
2.2.13 Hot-swap power supply replacement
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
CAUTION: Hazardous moving parts. Keep fingers and other body parts away.
CAUTION: Disconnect the hot-swap fan cables before removing the fan from the device to
protect against personal injury.
CAUTION: Never remove the cover on a power supply or any part that has the following
label attached.
1. Disconnect the power cord.
2. Push the latch and pull hot-swap power supply out.
31
Advertisement
Table of Contents
