Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 61

7. Type a volume size in the Capacity field and press Tab.
8. Press Enter to initiate volume creation.
9. When prompted, press Y to accept the warning message and create the volume.
10. If desired, return to step 2 to create additional RAID volumes.
11. When finished, select Exit and press Enter.
Deleting RAID volumes
This section describes how to use the Intel Rapid Storage Technology enterprise option ROM configuration
utility to delete RAID volumes.
To delete RAID volumes, do the following:
1. Press Ctrl+I when prompted to enter the Intel Rapid Storage Technology enterprise option ROM
configuration utility during system startup.
2. Use the up and down arrow keys to select Delete RAID Volume and press Enter.
3. Use the arrow keys to select the RAID volume to be deleted and press Delete.
4. When prompted, press Y to confirm the deletion of the selected RAID volume. Deleting a RAID volume
will reset the hard disk drives to non-RAID.
5. After deleting a RAID volume, you can:
• Return to step 2 to delete additional RAID volumes.
• See "Creating RAID volumes" on page 48 for RAID volume creation.
• Use the up and down arrow keys to select Exit and press Enter.
Resetting disks to non-RAID
This section describes how to reset your HDDs to non-RAID.
To reset your HDDs to non-RAID, do the following:
1. Press Ctrl+I when prompted to enter the Intel Rapid Storage Technology enterprise option ROM
configuration utility during system startup.
2. Use the up and down arrow keys to select Reset Disks to Non-RAID and press Enter.
3. Use the arrow keys and the space key to mark individual physical hard disk drives to be reset, and then
press Enter to complete the selection.
4. When prompted, press Y to confirm the reset action.
5. After resetting the HDDs to non-RAID, you can:
• See "Deleting RAID volumes" on page 49 for RAID volume deletion.
• See "Creating RAID volumes" on page 48 for RAID volume creation.
• Use the up and down arrow keys to select Exit and press Enter.
Marking disks as spare
To mark hard disk drives as spare drives, do the following:
1. During the system startup, press Ctrl+I when prompted to enter the Intel Rapid Storage Technology
enterprise option ROM configuration utility.
2. Use the up and down arrow keys to select Mark Disks as Spare and press Enter.
3. Use the arrow keys to locate a hard disk drive and press the space key to select or deselect the hard
disk drive. You can select multiple hard disk drives if required. Then, press Enter to complete the
selection.
4. When prompted, press Y to confirm the operation.
.
Chapter 4 Configuring the server
49