Setting The Terminal Port Baud Parameter; Modem Setup; Setting The Modem Port Baud Parameter - 3Com CoreBuilder 3500 Getting Started Manual

Setting the Terminal Port Baud Parameter

To change the baud setting of the terminal port from
the Administration Console, follow these steps:
From the top level of the Administration Console,
1
enter:
system serialPort terminalSpeed
At the prompt, enter the baud setting for the terminal
2
port. The system supports these baud settings:
19200, 9600, 4800, 2400, and 1200.
After you change the baud setting, you see this
message:
Changing the baud rate may cause a loss of
communication since you are currently connected
via the serial port.
Are you sure you want to change the baud rate?
(y/n):
Enter (for yes) or
3
y
If you enter , the baud setting is changed
y
immediately and you can no longer communicate on
the serial port until you adjust the baud setting of
your terminal or terminal emulator to match. If you
enter , the baud setting does not change and you
n
return to the previous menu.
(for no) at the prompt.
n

Modem Setup

You can set up your system for access through an
external modem that is attached to the system
processor's modem port. To do this, you must first set
the baud setting of the modem port (if necessary),
and then attach and configure your external modem.
Some modem vendors disable the autoanswer
parameter by default. Verify that your modem's
autoanswer parameter is not disabled. Consult your
modem's documentation for information on setting
this parameter.

Setting the Modem Port Baud Parameter

Your system is shipped with these modem serial port
parameters set as defaults: 9600 baud, 8 bits, no
parity, 1 stop bit.
To change the baud setting of the modem port
through the Administration Console, follow these
steps:
From the top level of the Administration Console,
1
enter:
system serialPort modemSpeed
At the prompt, enter the baud setting for the modem
2
port. The system supports these baud settings:
19200, 9600, 4800, 2400, and 1200.
Modem Setup 55