Setting The Time And Date; Setting Up Passwords - 3Com SuperStack II PathBuilder S330 Reference Manual

Setting the Time and
Date

Setting up Passwords

To set the time and date, follow these steps:
It is important to set the time and date accurately because these settings provide
the timestamp for alarms.
1 From the System Administration menu, select [2] Manage Time and Date to
display the Time and Date Configuration menu, shown in Figure 42.
Figure 42 Time and Date Configuration Menu
2 Select [1] Set Date. The following prompt appears at the bottom of the screen:
Enter Date (mm/dd/yy)
3 Enter the date.
4 Select [2] Set Time. The following prompt appears at the bottom of the screen:
Enter Time (hh:mm:ss):
5 Enter the time.
6 Select [3] Previous Menu to return to the System Administration menu.
7 Select [11] Previous Menu to return to the Main menu.
The PathBuilder S330/S310 supports a total of up to 10 logins at the following
three access levels:
Read-Only User—Can view information and configuration settings in the
PathBuilder S330/S310 interface, but cannot set parameters or make any changes.
Read-Write User—Can view and set/change configuration information.
Super User—Can view and set/change configuration information and can
perform the following super user functions:
Set passwords
n
Take over a read-write session
n
Erase the system database
n
Performing Initial System Configuration 69