Mac-Based Access Control Local Settings - D-Link DGS-3000 Series Reference Manual

Password
RADIUS Authorization
Local Authorization
Log State
Trap State
Max User (1-1000)
VLAN Name
VID (1-4094)
Member Ports
From Port / To Port
State
Mode
Aging Time (1-1440)
Block Time (0-300)
Max User (1-1000)
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.

MAC-based Access Control Local Settings

This window is used to configure a list of MAC addresses, along with their corresponding target VLAN, which will be
authenticated for the Switch. Once a queried MAC address is matched in this window, it will be placed in the VLAN
associated with it here. The Switch administrator may enter up to 128 MAC addresses to be authenticated using the
local method configured here.
To view this window, click Security > MAC-based Access Control (MAC) > MAC-based Access Control Local
Settings as shown below:
The fields that can be configured are described below:
Parameter
MAC address
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
in the MAC-based access control Local Database Settings window.
RADIUS – Use this method to utilize a remote RADIUS server as the authenticator for
MAC-based access control.
Enter the password for the RADIUS server, which is to be used for packets being sent
requesting authentication. The default password is "default".
Use the drop-down menu to enable or disable the use of RADIUS Authorization.
Use the drop-down menu to enable or disable the use of Local Authorization.
Use the drop-down menu to enable or disable log state.
Use the drop-down menu to enable or disable trap state.
Enter the maximum amount of users of the Switch. Select the No Limit check box to
have 1000 users.
Enter the name of the previously configured Guest VLAN being used for this function.
Click the radio button and enter a Guest VLAN ID.
Enter the list of ports that have been configured for the Guest VLAN.
Use the drop-down menus to select a range of ports to be configured for MAC-based
access control.
Use this drop-down menu to enable or disable MAC-based access control on the port or
range of ports selected in the Port Settings section of this window.
Toggle between Port-based and Host-based.
Enter a value between 1 and 1440 minutes. The default is 1440. Select the Infinite
check box to set this value to have no aging time.
Enter a value between 0 and 300 seconds. The default is 300.
Enter the maximum amount of users of the Switch. Select the No Limit check box to
have 1000 users.
Figure 8-36 MAC-based Access Control Local Settings window
Description
Enter the MAC address that will be added to the local authentication list here.
232