D-Link DGS-3000 Series Reference Manual page 140

After clicking the Group List
The fields that can be configured are described below:
Parameter
Multicast Address List
Click the Add button to add a new entry based on the information entered.
Click the <<Back button to discard the changes made and return to the previous page.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
IPv4 Limited Multicast Range Settings
This window is used to configure the ports and VLANs on the Switch that will be involved in the Limited IPv4 Multicast
Range. The user can configure the range of multicast ports that will be accepted by the source ports to be forwarded
to the receiver ports.
To view the following window, click L2 Features > Multicast Filtering > IPv4 Multicast Filtering > IPv4 Limited
Multicast Range Settings as shown below:
The fields that can be configured are described below:
Parameter
Ports / VID List
Access
Profile ID / Profile
Name
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specific entry.
Click the Find button to locate a specific entry based on the information entered.
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
link, the following window will appear:
Figure 4-79 Multicast Address Group List Settings window
Description
Enter the multicast address list.
Figure 4-80 IPv4 Limited Multicast Range Settings window
Description
Select the appropriate port(s) or VLAN IDs used for the configuration.
Assign access permissions to the ports selected. Options listed are Permit and Deny.
Use the drop-down menu to select the profile ID or profile name used and then assign
Permit or Deny access to them.
131