D-Link DGS-3000 Series Reference Manual page 149

Click the Apply button to accept the changes made for each individual section.
LLDP Port Settings
This window is used to configure the LLDP port parameters.
To view the following window, click L2 Features > LLDP > LLDP > LLDP Port Settings as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
Notification
Admin Status
Subtype
Action
Address
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
from an LLDP neighbor. To set the LLDP Notification Interval, enter a value in seconds (5
to 3600).
Figure 4-93 LLDP Port Settings window
Description
Use the drop-down menu to select the ports used for this configuration.
Use the drop-down menu to enable or disable the status of the LLDP notification. This
function controls the SNMP trap however it cannot implement traps on SNMP when the
notification is disabled.
This function controls the local LLDP agent and allows it to send and receive LLDP
frames on the ports. Options to choose from are TX, RX, TX and RX or Disabled.
TX - the local LLDP agent can only transmit LLDP frames.
RX - the local LLDP agent can only receive LLDP frames.
TX and RX - the local LLDP agent can both transmit and receive LLDP frames.
Disabled - the local LLDP agent can neither transmit nor receive LLDP frames.
The default value is TX And RX.
Use the drop-down menu to select the type of the IP address information will be sent.
Use the drop-down menu to enable or disable the action field.
Enter the IP address that will be sent.
140