System Log - D-Link DGS-3000 Series Reference Manual

The fields that can be configured are described below:
Parameter
Server ID
Severity
Server IPv4 Address
Server IPv6 Address
Facility
UDP Port (514 or
6000-65535)
Status
Click the Apply button to accept the changes made.
Click the Delete All button to remove all servers configured.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.

System Log

Users can view and delete the local history log as compiled by the Switch's management agent.
To view the following window, click System Configuration > System Log Configuration > System Log as shown
below:
The fields that can be configured or displayed are described below:
Parameter
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 2-22 System Log Server Settings
Description
Syslog server settings index (1 to 4).
Use the drop-down menu to select the higher level of messages that will be sent. All
messages which level is higher than selecting level will be sent. The options are
Emergency (0), Alert (1), Critical (2), Error (3), Warning (4), Notice (5), Informational (6)
and Debug (7).
Click to enter the IPv4 address of the Syslog server.
Click to enter the IPv6 address of the Syslog server.
Use the drop-down menu to select Local 0, Local 1, Local 2, Local 3, Local 4, Local 5,
Local 6, or Local 7.
Type the UDP port number used for sending Syslog messages. The default is 514.
Choose Enabled or Disabled to activate or deactivate.
Figure 2-23 System Log window
Description
27