D-Link DGS-3000 Series Reference Manual page 119

Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
IGMP Snooping Rate Limit Settings
On this page the user can configure the IGMP snooping rate limit parameters.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Rate
Limit Settings as shown below:
The fields that can be configured are described below:
Parameter
Port List
VID List
Rate Limit (1-1000)
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IGMP Snooping Static Group Settings
Users can view the Switch's IGMP Snooping Group Table. IGMP Snooping allows the Switch to read the Multicast
Group IP address and the corresponding MAC address from IGMP packets that pass through the Switch.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Static
Group Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
configuration.
Figure 4-46 IGMP Snooping Rate Limit Settings window
Description
Click the radio button and enter the port list used for this configuration.
Click the radio button and enter the VID list used for this configuration.
Enter the IGMP snooping rate limit used. Select the No Limit check box to ignore the rate
limit.
Figure 4-47 IGMP Snooping Static Group Settings window
110