Mac-Based Access Control Local Settings - D-Link DGS-3620-52P Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
VLAN Name
VID
Member Ports
From Port / To Port
State
Aging Time (1-1440)
Block Time (0-300)
Max User (1-4000)
Click the Apply button to accept the changes made for each individual section.

MAC-based Access Control Local Settings

Users can set a list of MAC addresses, along with their corresponding target VLAN, which will be authenticated for
the Switch. Once a queried MAC address is matched in this window, it will be placed in the VLAN associated with it
here. The Switch administrator may enter up to 128 MAC addresses to be authenticated using the local method
configured here.
To view this window, click Security > MAC-based Access Control (MAC) > MAC-based Access Control Local
Settings as shown below:
The fields that can be configured are described below:
Parameter
MAC address
VLAN Name
VID (1-4094)
Click the Add button to add a new entry based on the information entered.
Click the Delete by MAC button to remove the specific entry based on the MAC address entered.
Click the Delete by VLAN button to remove the specific entry based on the VLAN name or ID entered.
Click the Find by MAC button to locate a specific entry based on the MAC address entered.
Click the Find by VLAN button to locate a specific entry based on the VLAN name or ID entered.
Click the View All button to display all the existing entries.
Click the Edit by Name button to change the specific MAC address' VLAN name.
Click the Edit by ID button to change the specific MAC address' VLAN ID.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Enter the name of the previously configured Guest VLAN being used for this function.
Click the radio button and enter a Guest VLAN ID.
Enter the list of ports that have been configured for the Guest VLAN.
Use the drop-down menus to select a range of ports to be configured for MAC-based
access control.
Use this drop-down menu to enable or disable MAC-based access control on the port
or range of ports selected in the Port Settings section of this window.
Enter a value between 1 and 1440 minutes. The default is 1440. To set this value to
have no aging time, select the Infinite option.
Enter a value between 0 and 300 seconds. The default is 300.
Enter the maximum user used for this configuration. When No Limit is selected, there
will be no user limit applied to this rule.
Figure 8-27 MAC-based Access Control Local Settings window
Description
Enter the MAC address that will be added to the local authentication list here.
Enter the VLAN name of the corresponding MAC address here.
Enter the VLAN ID of the corresponding MAC address here.
342