Lldp-Med - D-Link DGS-3000 Series Reference Manual

After clicking the Show Normal button, the following window will appear:
Click the <<Back button to return to the previous page.

LLDP-MED

LLDP-MED System Settings
This window is used to configure the LLDP-MED log state and the fast start repeat count, and display the LLDP-MED
system information.
To view the following window, click L2 Features > LLDP > LLDP-MED > LLDP-MED System Settings as shown
below:
The fields that can be configured are described below:
Parameter
LLDP-MED Log State
Fast Start Repeat
Count (1-10)
Click the Apply button to accept the changes made for each individual section.
LLDP-MED Port Settings
This window is used to enable or disable transmitting LLDP-MED TLVs.
To view the following window, click L2 Features > LLDP > LLDP-MED > LLDP-MED Port Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 4-103 LLDP Remote Port Information – Show Normal window
Figure 4-104 LLDP-MED System Settings window
Description
Click to enable or disable the log state of LLDP-MED events.
Enter a value between 1 and 10 for the fast start repeat count. When an LLDP-MED
Capabilities TLV is detected for an MSAP identifier not associated with an existing LLDP
remote system MIB, then the application layer shall start the fast start mechanism and set
the 'medFastStart' timer to 'medFastStartRepeatCount' times 1. The default value is 4.
147