ILX Lightwave LDX-36000 Series User Manual page 86

5
C H A P T E R
Table 5.1 Remote Command Summary Reference List (Continued) (Sheet 5 of 5)
Name
LAS:STEP?
MES
MES?
*OPC
*OPC?
*PSC
*PSC?
*PUD
*PUD?
R?
RAD
RAD?
*RCL
*RST
*SAV
SECURE
*SRE
*SRE?
*STB?
T?
TERM
TERM?
TIME?
TIMER?
*TST?
*WAI
70
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Remote Command Reference Summary
Parameters Function
NONE Returns the laser current setpoint step value.
1 Used to enter a string message of up to 16 bits.
NONE Returns previously stored ASCII message.
NONE Generates the Operation Complete message in the Standard
Event Status Register.
NONE Places an ASCII character 1 into the Output Queue.
NONE Used to avoid any undesirable service requests.
NONE Queries the Power-On-Status-Clear Flag.
1 Stores Programmable User Data into instrument.
NONE Returns the Programmable User Data.
NONE Returns the measured thermistor resistance.
1 Sets the radix type for numerical data. Decimal, binary,
octal, or hexadecimal.
NONE Returns the radix type used for numerical data.
1 Used to recall a stored setup configuration.
NONE Forces a device reset.
1 Saves the current setup configuration.
Used to gain access to protected data.
1 Sets the bits in the Service Request Enable Register to allow
generation of user-selectable service requests.
NONE Returns the current contents of the Service Request Enable
Register.
NONE Returns the current contents of the Status Byte Register.
NONE Returns the currently measured temperature.
1 Used to add a carriage return to the device terminator.
NONE Returns the status of the TERM command.
NONE Returns the elapsed time since the instrument as last
powered up.
NONE Returns the elapsed time since the instrument was last
reset.
NONE Initiates an internal self-test and returns a response when
complete.
NONE Prevents executing any further commands until the
No-Operation-Pending flag is true.