ILX Lightwave LDX-36000 Series User Manual page 117

LASer:F <nrf value>
Action
Parameters
Notes
Examples
LASer:F?
Action
Parameters
Notes
Examples
03_10
Sets the output pulse frequency to be used in QCW-Pulse mode or Hard Pulse mode.
One <nrf value> specifying the pulse frequency in the range of 1-1000 Hz.
The frequency is adjustable only in the QCW-Pulse mode or Hard Pulse mode.
QCW:TRIG mode relies on external trigger inputs. If the command is given while in
QCW-Trig mode, the command will be accepted but no action will occur until the correct
operational mode has been entered.
If the new value for (command specific parameter) forces the duty cycle or frequency
beyond the operational range of the instrument, the (command specific parameter) will
be clamped to a minimum or maximum value that still allows operation. You may query
the command to determine if the setpoint was out of range.
"LAS:F 150" -action: sets the QCW-Pulse or Hard Pulse frequency to 150 Hz.
Returns the output pulse frequency set in QCW-Pulse or Hard Pulse mode.
None.
The frequency may be read from any operational mode but is only applicable to output
while in the QCW-Pulse or Hard Pulse mode.
"LAS:F?" -response: 260, means that the QCW-Pulse or Hard Pulse frequency is set to
260 Hz.
C O M M A N D R E F E R E N C E
Command Reference
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
101
LDX-36000 Series
