ILX Lightwave LDX-36000 Series User Manual page 109

LASer:DISplay:PWP?
Action
Parameters
Notes
Examples
LASer:DISplay:T
Action
Parameters
Notes
Examples
LASer:DISplay:T?
Action
Parameters
Notes
Examples
03_10
Returns the status of the constant duty cycle pulsewidth setpoint display.
None.
In local operation, the status of either PW button is indicated by the annunciator to the
right of Display 2 (ms will be illuminated when the display is in PW mode).
"LAS:DIS:PWP?" -response: 0, means that the pulsewidth setpoint display on Display 2
is not currently active.
"LAS:DIS:PWP?" -response: 1, means that the pulsewidth setpoint display on Display 2
is currently active.
Sets Display 2 (secondary display) to show measured temperature.
None.
The temperature display is enabled only when all three Steinhart-Hart constants are
nonzero.
The output current setpoint display is automatically turned off when another display
selection is enabled.
"LAS:DIS:T" -action: enables the temperature measurement display on Display 2.
Returns the status of the temperature measurement display.
None.
In local operation, the status of the T button is indicated by the annunciator to the right of
Display 2 (°C will be illuminated when the display is in T mode).
"LAS:DIS:T?" -response: 0, means that the temperature measurement display is not
currently active.
"las:dis:t?" -response: 1, means that the temperature measurement display is currently
active.
C O M M A N D R E F E R E N C E
Command Reference
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
93
LDX-36000 Series
