ILX Lightwave LDX-36000 Series User Manual page 113

LASer:ENABle:EVEnt?
Action
Parameters
Notes
Examples
03_10
Returns the value of the Status Enable Event Register.
None.
The response is the sum of the enabled bits and must be a value between 0 and 65535
as detailed below.
1 Laser Current Limit
2 Laser Voltage Limit
4 High Temperature Limit
8 Laser Open Circuit
16 Interlock 1 State Change
32 Interlock 2 State Change
64 Temp Sensor Open
128 Temp Sensor Shorted
The enabled or disabled conditions can be set via the LASer:ENABle:EVEnt command.
"LAS:ENAB:EVENT?" -response: "258", means a laser voltage limit or output status
change will be reported (in summarized form) to the Status Byte Register (Bit 2).
"Rad Hex; Laser:Enable:Eve?" -response: "#H30", means that an interlock opening or
closing will be reported to the Status Byte Register.
C O M M A N D R E F E R E N C E
Command Reference
256 Output On
512 Bad Steinhart-Hart Conversion
1024 Hardware Current Limit
2048 AC Power Failure
4096 Laser Open Circuit 2
8192 Power Supply Failure
16384 Power Supply Voltage Limit
32768 Pass Element Power Limit
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
97
LDX-36000 Series
