ILX Lightwave LDX-36000 Series User Manual page 31

13. % of set point, at the end of ILX CC-390 cable into a low inductance load. Overshoot may increase with inductance.
14. Voltage limit is higher than compliance to ensure output is not disabled due to overshoot caused by impedance mismatch.
15. Firmware controlled limit accuracy. Internal hardware limit scaled with setpoint limit.
16. From start of ouput pulse to trigger.
17. From start of trigger to output pulse.
18. % of reading + offset.
19. % of FS.
20. The responsivity value is user-defined and is used to calculate optical power.
o
21. At 25 C, accuracy while using ILX Lightwave TS-510 calibrated 10 k thermistor.
22. Interlock fault time measured from event to device shorting protection enabled.
23. Total external dimensions including handles and support feet. Handles add 1.5" (3.8 cm) and feet add 0.56" (1.4 cm) to overall dimensions.
24. Hardware fault detection time due to an open circuit, intermittent contact, voltage or current limit, AC power failure.
25. Pulse mode specifications are also external trigger mode specifications.
In keeping with our commitment to continuous improvement, ILX Lightwave reserves the right to
change specifications without notice for such changes.
03_10
I N T R O D U C T I O N A N D S P E C I F I C A T I O N S
C H A P T E R
Specifications
LDX-36000 Series
1
15
