Remote Command Reference Summary; Table 5.1 Remote Command Summary Reference List - ILX Lightwave LDX-36000 Series User Manual

5
C H A P T E R

Remote Command Reference Summary

This section contains all of the commands for the LDX-36000 Series High Power
Current Source, listed in alphabetical order. Subsections for each path are
presented, listing the commands which are legal for that path. See Figure 4.4 for
the command path tree structure.
Table 5.1 Remote Command Summary Reference List (Sheet 1 of 5)
Name
*CLS
DELAY
ERR?
*ESE
*ESE?
*ESR?
*IDN?
LAS:CAL:LDI
LAS:CAL:LDI?
LAS:CAL:LDV
LAS:CAL:LDV?
LAS:CAL:LIMITI
LAS:CAL:LIMITI?
LAS:CAL:LIMITV
LAS:CAL:LIMITV?
LAS:CAL:MDI
LAS:CAL:MDI?
LAS:CAL:THERMI
66
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Remote Command Reference Summary
Parameters Function
NONE Resets the Standard Event Register, Status Byte and Error
Queue to zero.
1 Creates a delay in the execution of further commands.
NONE Returns errors generated since the last query.
1 Sets the Standard Event Status Enable Register.
NONE Returns the value of the Standard Event Status Enable
Register
NONE Returns the value of the Standard Event Status Register
NONE Returns the Device Identification string.
2 Enters the slope and offset calibration constants for the laser
current setpoint.
NONE Returns the slope and offset calibration constants for the
laser current setpoint.
2 Enters the slope and offset calibration constants for the laser
compliance voltage measurement.
NONE Returns the slope and offset calibration constants for the
laser compliance voltage measurement.
2 Enters the slope and offset calibration constants for the laser
current limit setpoint.
NONE Returns the slope and offset calibration constants for the
laser current limit setpoint.
2 Enters the slope and offset calibration constants for the laser
voltage limit setpoint.
NONE Returns the slope and offset calibration constants for the
laser voltage limit setpoint.
2 Enters the slope and offset calibration constants for the
monitor photodiode current measurement.
NONE Returns the slope and offset calibration constants for
photodiode current measurement.
2 Enters the slope and offset calibration constants for
thermistor current.