ILX Lightwave LDX-36000 Series User Manual page 114

5
C H A P T E R
LASer:ENABle:OUTOFF <nrf value>
Action
Parameters
Notes
Examples
98
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Command Reference
Sets the Output Off Enable Register.
An <nrf value> whose sum represents the enabled bits.
The sum of the enabled bits and must be a value between 0 and 65535 as described
below.
1 Laser Current Limit
*2 Laser Voltage Limit
4 High Temperature Limit
*8 Laser Open Circuit
*16 Interlock #1 Open
*32 Interlock #2 Open
64 Temp Sensor Open
128 Temp Sensor Shorted
Bits marked with an asterisk (*) are permanently enabled and cannot be changed.
Bits marked with a dagger (
The enabled or disabled conditions can be read via the LASer:ENABle:OUTOFF? query.
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition in the IEEE-488.2 specification).
The factory default value for this register is #B1111110000111110, or #HFC3E, or 64574
decimal.
"LAS:ENAB:OUTOFF 1791" -action: enables the Output Off Register so the laser output
will be disabled if any of the conditions listed above occur.
"las:enab:outoff 0" -action: disables all output off conditions except those that are
permanently enabled.
†
256 Output Enabled
512 Bad Steinhart-Hart Conversion
*1024 Hardware Current Limit
2048 * AC Power Failure
*4096 Laser Open Circuit 2
*8192 Power Supply Failure
*16384 Power Supply Voltage Limit
*32768 Pass Element Power Limit
†
) are permanently disabled and cannot be changed.
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT