ILX Lightwave LDX-36000 Series User Manual page 75

Table 4.8 LDX-36000 Commonly Used Commands (Continued) (Sheet 2 of 2)
Command
LAS:MODE:TRIG
LAS:OUT
LAS:OUT?
LAS:P
LAS:P?
LAS:PDBIAS
LAS:PDBIAS?
LAS:PPD?
LAS:PW?
LAS:PWF
LAS:PWP
R?
T?
03_10
LDX-36000 Commonly Used Commands
Parameters Function
NONE Sets the output mode to pulsed; output is initiated by an
external trigger signal
1 Enables/disables current source output
NONE Returns current source output status
1 Sets output current setpoint in terms of input optical power
based on threshold and slope efficiency values
NONE Returns output current setpoint in terms of optical power
based on threshold and slope efficiency values
1 Sets the reverse bias voltage (0 to -15 V) on an external
photodiode connected to pins 1 and 2 of the sense 9-pin
connector
NONE Returns PD bias reverse voltage value in volts
NONE Returns monitor photodiode power value or photocurrent if
responsivity value is not entered
NONE Returns current pulsewidth value
1 Sets pulsewidth while holding frequency constant; duty
cycle percentage will change
1 Sets pulsewidth while holding duty cycle percentage
constant; frequency will change
NONE Returns thermistor resistance measurement
NONE Returns current temperature measurement
R E M O T E O P E R A T I O N
4
C H A P T E R
59
LDX-36000 Series
