ILX Lightwave LDX-36000 Series User Manual page 103

LASer:DELAYOUT <nrf value>
Action
Parameters
Notes
Examples
LASer:DELAYOUT?
Action
Parameters
Examples
03_10
Configures the delay, in seconds, between an output QCW pulse and the output trigger.
One <nrf value>, representing the delay in seconds with a range of 0 to 1 second with a
resolution of 1 µs.
The default value is 0 seconds.
In QCW mode (any mode), a 10 µs trigger pulse is output from the rear panel Trigger Out
BNC with each current pulse. The trigger pulse is synchronous with the rising edge of
the current pulse and may be delayed by the amount specified with the LAS:DELAYOUT
command.
Refer to Figure 3.17 for a QCW timing diagram illustrating the relationship between input
and output pulses.
The LDX-36000 cannot determine the pulse period when externally triggered in
QCW-Trig mode. Therefore, setting the delay to be longer than the pulse period will lead
to unpredictable results.
"LAS:DELAYOUT 135e-6" -action: Sets the output trigger delay to 135 µs from the rising
edge of the output current pulse.
Returns the delay, in seconds, between an output QCW pulse and the output trigger.
None.
"LAS:DELAYOUT?" -response: "2.5e-3", means the delay between an output current
pulse and the trigger output is 2.5 ms.
C O M M A N D R E F E R E N C E
Command Reference
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
87
LDX-36000 Series
