ILX Lightwave LDX-36000 Series User Manual page 85

Table 5.1 Remote Command Summary Reference List (Continued) (Sheet 4 of 5)
Name
LAS:LIM:T?
LAS:LIM:V
LAS:LIM:V?
LASer:LIV:OUTPUT
LASer:LIV:OUTPUT?
LASer:LIV:GETMEAS?
LASer:LIV:STEP
LASer:LIV:STEP?
LAS:MODE?
LAS:MODE:CW
LAS:MODE:HPULSE
LAS:MODE:PULSE
LAS:MODE:TRIG
LAS:OUT
LAS:OUT?
LAS:P
LAS:P?
LAS:PDBIAS
LAS:PDBIAS?
LAS:PPD?
LAS:PW?
LAS:PWF
LAS:PWP
LAS:STEP
03_10
C O M M A N D R E F E R E N C E
Remote Command Reference Summary
Parameters Function
NONE Returns the laser high temperature limit.
1 Sets the laser compliance voltage limit.
NONE Returns the laser compliance voltage limit.
1 Enables / disables the LIV instrument mode; the instrument
will step the setpoint current in the amount of time specified
by the delay value from the start value to the stop value at
increments defind by the step value.
NONE Returns the LIV mode output status.
NONE Returns the LIV data from memory, in a group of 25 data
points. For each step, photodiode current, laser current
setpoint, and laser forward voltage values are saved to
memory.
4 Specifies the start current, stop current, step current, and
delay for LIV mode.
NONE Returns the start current, stop current, step current, and
delay for LIV mode.
NONE Returns the laser output mode.
NONE Sets the output mode to CW.
NONE Sets the output mode to hard pulse mode
NONE Sets the output mode to QCW-Pulse.
NONE Sets the output mode to QCW-External Trigger.
1 Enables/disables the current source output.
1 Returns the laser current output status.
1 Specifies the output optical power from which is calculated
the current source setpoint value.
NONE Returns the optical power from which the current source
setpoint is calculated.
1 Sets the reverse bias voltage (0 to -15V) on an external
photodiode connected to pins 1 and 2 of the sense 9-pin
connector
NONE Returns the PD reverse bias voltage value in volts
NONE Returns measured optical power from external, calibrated
photodiode.
NONE Returns the pulsewidth setpoint in seconds.
1 Specifies the pulsewidth to be output QCW mode. Duty
cycle will change to maintain constant frequency.
1 Specifies the pulsewidth to be output QCW mode.
Frequency will change to maintain constant duty cycle.
1 Sets laser current setpoint step value.
5
C H A P T E R
69
LDX-36000 Series 