ILX Lightwave LDX-36000 Series User Manual page 112

5
C H A P T E R
LASer:ENABle:EVEnt <nrf value>
Action
Parameters
Notes
Examples
96
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Command Reference
Sets the Laser Status Enable Event Register for summary (in bit 2 of the Status Byte) and
generation of service requests.
An <nrf value> whose sum represents the enabled bits.
The sum of the enabled bits and must be a value between 0 and 65535 as detailed
below.
1 Laser Current Limit
2 Laser Voltage Limit
4 High Temperature Limit
8 Laser Open Circuit
16 Interlock 1 State Change
32 Interlock 2 State Change
64 Temp Sensor Open
128 Temp Sensor Shorted
The enabled or disabled conditions can be read via the LASer:ENABle:EVEnt? query.
The event status can be monitored by the LASer:EVEnt? query. If any of the enabled
conditions are true, Bit 2 of the Status Byte Register will be set.
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition in the IEEE-488.2 specification).
"LAS:ENAB:EVENT 3" -action: enables the Status Condition Register so that the current
and voltage limit conditions will be summarized in the Status Byte.
"Laser:Enable:Cond #H0100" -action: enables the status condition register so that when
the output is on , it will be reported in the Status Byte Register.
C
OMMON
F
RONT
D
EVICE
256 Output On
512 Bad Steinhart-Hart Conversion
1024 Hardware Current Limit
2048 AC Power Failure
4096 Laser Open Circuit 2
8192 Power Supply Failure
16382 Power Supply Voltage Limit
32768 Pass Element Power Limit
P
ANEL
D
EPENDENT