ILX Lightwave LDX-36000 Series User Manual page 116

5
C H A P T E R
LASer:EVEnt?
Action
Parameters
Notes
Examples
100
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Command Reference
Returns the value of the Status Event Register.
None.
The response is the sum of the enabled bits and must be a value between 0 and 65535
as detailed below.
1 Laser Current Limit
2 Laser Voltage Limit
4 High Temperature Limit
8 Laser Open Circuit
16 Interlock 1 State Change
32 Interlock 2 State Change
64 Temp Sensor Open
128 Temp Sensor Shorted
The enabled or disabled events can be set via the LASer:ENABle:EVEnt command.
The event status is only cleared when the event status is read or by the *CLS command,
while the condition status (LAS:COND?) is constantly changing.
"LAS:EVE?" -response: "257" means, that the output status has changed and current
limit events have occurred since the last LASer:EVEnt? query.
C
OMMON
F
RONT
D
EVICE
256 Output On
512 Bad Steinhart-Hart Conversion
1024 Hardware Current Limit
2048 AC Power Failure
4096 Laser Open Circuit 2
8192 Power Supply Failure
16384 Power Supply Voltage Limit
32768 Pass Element Power Limit
P
ANEL
D
EPENDENT