ILX Lightwave LDX-36000 Series User Manual page 134

5
C H A P T E R
*RCL <nrf value>
-Recall
Action
Parameters
Notes
Examples
*RST
-Reset
Action
Parameters
Notes
Examples
*SAV <nrf value>
-Save
Action
Parameters
Notes
Examples
118
 LDX-36000 Series
C O M M A N D R E F E R E N C E
Command Reference
Recalls a stored setup configuration from memory.
One <nrf value> with a value from 0 - 10.
Configuration 0 is the factory-set default configuration.
If Configuration 0 is recalled via GPIB, the instrument will be in Remote mode. If it is
recalled from the font panel, the instrument will be in Local mode.
The *SAV function is used to save configurations for convenient recall.
The current setup is automatically stored and recalled at the next power-on, unless *PSC
is used to enable the power-on status clear flag.
"*RCL 0" -response: instrument is reconfigured to factory-default settings.
Performs a device reset and sets the OCIS and OQIS states.
None.
OCIS = Operation-complete Command Idle State. This is the same as after *OPC - no
further operations to complete.
OQIS = Operation-complete Query Idle State. This is the same as after *OPC? - no
further operations to complete.
These states allow the instrument to complete its reset process (no operations pending)
before continuing with other operations.
*RST
Saves the current instrument configuration to non-volatile memory.
One <nrf value> with a value from 1 - 10.
Configuration 0 is reserved for the factory-set default configuration.
It is normally not necessary to save the current setup for next power-on. The current
setup is automatically stored for recall at next power-on, unless the *PSC command is
used to clear the power-on status.
"*SAV 3" -response: the current instrument configuration is stored in memory location
#3.
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT