ILX Lightwave LDX-36000 Series User Manual page 137

TIME?
Action
Parameters
Notes
Examples
TIMER?
Action
Parameters
Notes
Examples
*TST?
-Self Test
Action
Parameters
Notes
Examples
*WAI
-Wait to Continue
Action
Parameters
Notes
Examples
03_10
Returns the amount of time since the LDX-36000 was last powered up.
None.
The TIME and TIMER clocks are independent from each other.
"Time?" -response: "0:00:31.73" means 31.73 seconds have elapsed since the
instrument was turned on.
Returns the amount of time since the last TIMER? query.
None.
The TIME and TIMER clocks are independent from each other.
"Timer?" -response: "'0:02:56.34" means 2 minutes 56.34 seconds have elapsed since
the last TIMER? query.
Performs an internal self-test, then reports results.
None.
Response 0 = test completed with no errors.
Response non-zero = test not completed or completed with errors.
"*TST?" -response: "0" means test completed without errors.
Prevents the instrument from executing any further commands until OPC (operation
complete) status is true.
None.
This command can be used to make the instrument wait until an operation is complete
before continuing.
Care should be taken to set the GPIB time-out appropriately for use with the *WAI
command. After this command (or the Delay) command is sent, the instrument may
receive up to 20 more commands before the wait period is over. If more than 20
commands are sent before the delay or wait period is over, the additional commands will
be ignored and an error E-220 will be generated.
"*WAI" -action: wait until OPC status is true.
C O M M A N D R E F E R E N C E
Command Reference
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
121
LDX-36000 Series
