ILX Lightwave LDX-36000 Series User Manual page 111

LASer:ENABle:COND?
Action
Parameters
Notes
Examples
03_10
Returns the value of the Status Condition Enable Register.
None.
The response is the sum of the enabled bits and is detailed below.
1 Laser Current Limit
2 Laser Voltage Limit
4 High Temperature Limit
8 Laser Open Circuit
16 Interlock 1 Error
32 Interlock 2 Error
64 Temp Sensor Open
128 Temp Sensor Shorted
The enabled conditions can be set via the LASer:ENABle:COND command.
The condition status can be monitored by the LASer:COND? query.
"LAS:ENAB:COND?" -response: 260, means the high temperature limit and output on
conditions will be reported to the Status Byte (Bit 3).
"Radix Hex; Laser:Enable:Cond?" -response: "#HFFFF" means that any and all of the
above conditions will be reported to Bit 3 of the Status Byte.
C O M M A N D R E F E R E N C E
Command Reference
256 Output On
512 Bad Steinhart-Hart Conversion
1024 Hardware Current Limit
2048 AC Power Failure
4096 Laser Open Circuit 2
8192 Power Supply Failure
16384 Power Supply Voltage Limit
32768 Pass Element Power Limit
5
C H A P T E R
C
OMMON
F P
RONT ANEL
D D
EVICE EPENDENT
95
LDX-36000 Series
