Save / Recall Waveforms And Setups - Hantek 1060 User Manual

1060/1200/1600/1600H
Sweep
2/2
Term interpretation
■ Auto:
This sweep mode allows the oscilloscope to acquire waveforms even when it does
not detect a trigger condition. If no trigger condition occurs while the oscilloscope is
waiting for a specific period (as determined by the time-base setting), it will force itself
to trigger.
When forcing invalid triggers, the
and the waveform seems to roll across the display. If valid triggers occur, the display
becomes stable on the screen. Any factor results in the un-stability of waveforms can
be detected by Auto Trigger, such as the output of Power supply.
NOTE: When horizontal control is set more than 50 ms/div, Auto mode allows the
oscilloscope to capture without trigger signal.
■ Normal:
The Normal mode allows the oscilloscope to acquire a waveform only when it is
triggered. If no trigger occurs, the oscilloscope keeps waiting, and the previous
waveform, if any, will remain on the display.
■ Single:
In Single mode, after pressing the RUN/STOP key, the
While the trigger occurs, the oscilloscope acquires one waveform then stop.

Save / Recall Waveforms and Setups

Save/Recall
Press the
The Save/Recall Menu Table
Menu
Type
Internal
Force the oscilloscope to trigger in the absence condi-
Auto
ton
Let oscilloscope to trigger in the suitable trigger condi-
Normal
ton
Let osclloscope to trigger one time in the suitable trig-
Single
ger condition,then stop
Back to the previous menu page
button, the interface menu for settings shows as follows.
Setting
Wave Store or recall waveform
Setup Store or recall instrument setups
Bitmap Create or delete bitmap files
CSV Create or delete CSV files
Factory Recall factory setups
Go to menu for internal memory operation
ll cannot synchronize the waveform,
Description

ll waits for trigger.