The calibration screen is shown as in Figure 2-43.
Note:
The
ll
must have been working or warm-up at least 30-minutes before
running calibration to get best accuracy.
The
ll
will calibrate parameter of vertical system (CH1, CH2).
Pass/Fail
The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal is within the pre-defined mask.
Utility→Pass/Fail
Press
The Pass/Fail menu (Page 1/2)
Figure 2-43 The Calibration Screen
to go to the following menu.
DSO1000 SERIES
HANDHELD OSCILLOSOPE