Hantek 1060 User Manual page 45

The Pulse Trigger Table (Page 2/2)
Menu Setting
2/2
Auto
Sweep Normal
Single
HF ON
Reject OFF
50%
2/2
Note
: The Pulse width adjust range is10ns ~ 10s. When the condition is met, it will
trigger and acquire the waveform.
ALT (Alternative) Trigger Setting
When alternative trigger is on, the trigger sources come from two vertical channels. This
mode can be used to observe two non-related signals. You can choose two different
trigger modes for the two vertical channels. The options are as follows: Edge, Pulse. The
info of the trigger level of the two channels will be displayed on the upper-right of the
screen.
See the ALT screen in figure 2-29.
TRIG → F1 → ALT
Press
The ALT Trigger menu (Type Edge)(Page 1/2)
The ALT menu table (Type Edge)( Page 2/2)
Menu Setting
Channel
Back to the previous menu page
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform and then stop
Reject high frequency signals
Set the trigger level to the center of the signal
Back to the previous menu page
button to show the ALT trigger menu as the following table.
Figure 2-30 The ALT trigger menu
CH1 Set trigger for CH1
CH2 Set trigger for CH2
DSO1000 SERIES
HANDHELD OSCILLOSOPE
Description
Description