Hantek 1060 User Manual page 74

1060/1200/1600/1600H
Press the button F2 in the IO Set menu(RS232),you can modify Baud Rate value.
See the IO Set menu (RS232) in Figure 2-64.
Acquire
When you acquire an analog signal, the oscilloscope will convert it into a digital one.
There are two kinds of acquisition: Real-time acquisition and Equivalent acquisition. The
real-time acquisition has three modes: Sample, Peak Detect, and Average. The
acquisition rate is affected by the setting of time base.
→ F4 button to show the menu of Qcquire.
Press UTILITY
Peak:the oscilloscope gets the maximum and minimum values of the input signal over
each sample interval and uses these values to display the waveform.
Sinx/x: The Sinx/x can be used in time base range of 50ns~5ns.
Figure 2-65 the Lan Setting window