Chapter 3 Using Examples - Hantek 1060 User Manual

Chapter 3 Using examples

Example 1: Simple Measurement
To acquire and display a signal, please do the steps as followings:
1. Connect signal to CH1 by using probe.
2. Press the key AUTO on key panel.
The ll set the vertical, horizontal, and triggers controls at the best status
automatically. Also, you can adjust the controls to meet your measurements to optimize
the waveform display.
To measure the frequency and Vpp, you can do these steps as followings:
1. Press the key MEAS , Select Source -> CH1 and select Type ->Voltage, then press
the key F5 and then press the key F2 to make a Pk to Pk test. The Vpp value will
display on the bottom of the waveform interface.
2. Press the key MEAS, select Source ->CH1and select type->Time, then Press the
key F5 and then press the key F2 to make a Frequency test. The Frequency value will
display on the bottom of the waveform interface.
3. Click the item Clear in the Measure menu, To clear the measurements on the
waveform interface.
See the measurements in the figure 3-1.
DSO1000 SERIES
HANDHELD OSCILLOSOPE