Chapter 5: Troubleshooting - Hantek 1060 User Manual

Chapter 5: Troubleshooting

1.The oscilloscope cannot start.
1) Check the power cable connection.
2) Ensure the power switch is turned on.
3) After the above inspection, restart the oscilloscope.
4) If the problem still remains, please contact us for help.
2. The measurement result is 10 times higher or lower than the value expected.
Check if the probe attenuation is the same as the channel attenuation.
3. The waveform is displayed on the screen but is not stable under the oscillosco­
pe mode.
1) Check the Trigger Source and notice if it is set to the channel in use.
2) Check the Trigger Type.
4. When select the average sampling in the sampling mode or select a long
display time in the display mode under the oscilloscope, the display speed is
slow.
It is normal in the above case.
DSO1000 SERIES
HANDHELD OSCILLOSOPE