Hantek 1060 User Manual page 44

1060/1200/1600/1600H
50%
Pulse Trigger Setting
Pulse trigger occurs according to the width of pulse. The abnormal signals can be
detected through setting up the pulse width condition.
Press TRIG → F1 → Pulse button to show the pulse trigger menu as the following table.
The Pulse Trigger menu (Page 1/2)
The Pulse Trigger menu (Page 2/2)
Menu
Source
When
Setting
1/2
Set the trigger level to the center of the signal
Figure 2-27 The Pulse Trigger Menu
Figure 2-28 The Pulse Trigger Menu
The Pulse Trigger Table (Page 1/2)
Setting
CH1
Define CH1 or CH2 as trigger signal
CH2
+Pulse width more than selecting pulse condition
+More
+Pulse width less than selecting pulse condtion
+Less
+Pulse width equal to selecting pulse condition
+Equal
-Pulse width more than selecting pulse condition
-More
-Pulse width less than selecting pulse condition
-Less
-Pulse width equal to selecting pulse condition
-Equal
Value Set required pulse width
Go to the next menu page
Description