Hantek 1060 User Manual page 86

1060/1200/1600/1600H
Figure 4-3 Diode Measurement
To perform an On-off test, do the following:
1) Press the On-off key and then On-off indictor appears on the top of the screen.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black leads to the tested points. If the resistance value of the
tested points is less than 30 Ω, you will hear beep sound from the test tool.
Then, the screen will look like the following figure 4-4.