Hantek 1060 User Manual page 69

Mode
Type
Source
Cursor A
Cursor B
The ll measures the Y or X coordinate values of the cursors, and the
increments between the two cursors.
To do cursor measurements, please do as the following steps:
1. Turn on the cursor measurement:
Cursor→Mode→Manual / Track / Auto.
2. Select channel Source for measurements by pressing soft button as:
Cursor→Source→CH1 / CH2 / MATH.
3. Select the cursors type by pressing soft button as Cursor→Type→ X or Y.
4. Press F4 or F5 to select the Cursor A or Cursor B.
5. Move the cursors to adjust the increment between the cursors.
The values will be automatically displayed on the right upper corner of screen when the
cursor function menu is hidden or displaying other menus.
Comments of Cursor Measurements
1. Auto Cursor Mode
The Auto Cursor Mode displays the cursors for the current measuring automatically. See
figure 2-60.
Manual Set to Manual Mode
Track Set to Track Mode
Auto Set to Auto Mode
OFF Turn off the cursor measure
Shown as vertical line to measure the horizontal
X
parameters
Shown as horizontal line to measure the vertical
Y
parameters
CH1
Select the measurement signal source
CH2
MATH
Select Cursor A or not
Select Cursor B or not
DSO1000 SERIES
HANDHELD OSCILLOSOPE