Interactive Technologies, Inc.
Release v1.4.1 [February 24, 2016]
Version 1.4.1b (2/24/2016)
• Windows Installer
◦
Addressed a problem with the Windows installer that corrupted the application in a way
Bug
that would cause it to not be able to properly create new offline show files [Windows Only].
Version 1.4.1 (2/9/2016)
• CueServer Studio 2
◦
Editor Windows now darken and display a "CueServer Offline" message when the
Feature
device becomes unreachable.
◦
Addressed a problem that would cause cue display problems and a crash in the stream
Bug
capture window on host computers that are localized to use a comma as the decimal value
separator.
◦
Addressed a problem that could cause some show files to not appear in the Navigator
Bug
window when multiple CueServers' show listings were being displayed at the same time.
◦
Addressed a problem that could cause the "Input Status" indicator in the Settings > DMX >
Bug
Universes panel to show an improper status.
◦
Addressed a problem introduced in v1.4.0 that caused a warning icon to appear for the
Bug
Settings > DMX navigation item for offline shows.
◦
Addressed a problem that caused Blue LED Indicators on the CueServer device to appear
Bug
Magenta in CueServer Studio.
◦
Addressed a problem that caused the Indicators in the Status > Front Panel to not be
Bug
labeled properly.
• Firmware
◦
Temporary internal files are no longer stored in non-volitale memory to reduce wear on
Feature
flash memory.
◦
Changed the default subnet mask after factory reset to 255.0.0.0.
Feature
◦
Fixed a problem that caused the IP Address to show "No Address" when the Ethernet
Bug
cable was unplugged, instead of properly showing the IP Address.
◦
Special Note
(or lower) without assistance from Technical Support. Downgrading firmware is not typically
necessary. Should a situation arise that requires a firmware downgrade, please contact
Technical Support first.
Devices running firmware version 1.4.1 (or higher) can not be downgraded to 1.4.0
CueServer 2 User's Manual - 18.5.18
Page 392 of 429
Need help?
Do you have a question about the CueServer 2 and is the answer not in the manual?