Ignition Park Interlock; Brake/Transmission Shift Interlock System; Eight-Speed Automatic Transmission - Chrysler 300 2017 Owner's Manual

Hide thumbs Also See for 300 2017:
Table of Contents

Advertisement

CAUTION!
Damage to the transmission may occur if
the following precautions are not observed:
• Shift into or out of PARK or REVERSE only
after the vehicle has come to a complete
stop.
• Do not shift between PARK, REVERSE,
NEUTRAL, or DRIVE when the engine is
above idle speed.
• Before shifting into any gear, make sure
your foot is firmly pressing the brake pedal.
NOTE:
You must press and hold the brake pedal while
shifting out of PARK.

Ignition Park Interlock

This vehicle is equipped with an Ignition Park
Interlock which requires the transmission to be
in PARK before the ignition can be turned to the
OFF mode. This helps the driver avoid inadver-
tently leaving the vehicle without placing the
transmission in PARK. This system also locks
the transmission in PARK whenever the ignition
is in the OFF mode.
NOTE:
The transmission is NOT locked in PARK when
the ignition is in the ACC mode (even though the
engine will be off). Ensure that the transmission
is in PARK, and the ignition is OFF (not in ACC
mode) before exiting the vehicle.
142
Brake/Transmission Shift Interlock
System
This vehicle is equipped with a Brake Transmis-
sion Shift Interlock system (BTSI) that holds the
transmission gear selector in PARK unless the
brakes are applied. To shift the transmission out
of PARK, the engine must be running and the
brake pedal must be pressed. The brake pedal
must also be pressed to shift from NEUTRAL
into DRIVE or REVERSE when the vehicle is
stopped or moving at low speeds.

Eight-Speed Automatic Transmission

WARNING!
• Never use the PARK position as a substi-
tute for the parking brake. Always apply the
parking brake fully when exiting the vehicle
to guard against vehicle movement and
possible injury or damage.
• Your vehicle could move and injure you
and others if it is not in PARK. Check by
trying to move the transmission gear selec-
tor out of PARK with the brake pedal re-
leased. Make sure the transmission is in
PARK before exiting the vehicle.
• The transmission may not engage PARK if
the vehicle is moving. Always bring the
vehicle to a complete stop before shifting to
PARK, and verify that the transmission
WARNING! (Continued)
gear position indicator solidly indicates
PARK (P) without blinking. Ensure that the
vehicle is completely stopped, and the
PARK position is properly indicated, before
exiting the vehicle.
• It is dangerous to shift out of PARK or
NEUTRAL if the engine speed is higher
than idle speed. If your foot is not firmly
pressing the brake pedal, the vehicle could
accelerate quickly forward or in reverse.
You could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and your
foot is firmly pressing the brake pedal.
• Unintended movement of a vehicle could
injure those in or near the vehicle. As with
all vehicles, you should never exit a vehicle
while the engine is running. Before exiting
a vehicle, always come to a complete stop,
then apply the parking brake, shift the
transmission into PARK, and turn the igni-
tion OFF. When the ignition is in the OFF
mode, the transmission is locked in PARK,
securing the vehicle against unwanted
movement.
(Continued)
(Continued)

Advertisement

Table of Contents
loading

Table of Contents