Table of Contents
Advertisement
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security system:
1. Make sure the vehicle's ignition is placed in the OFF
position.
○
For vehicles equipped with Keyless Enter 'n
Go™ — Passive Entry, make sure the vehicle
ignition system is OFF.
2. Perform one of the following methods to lock the
vehicle:
○
Push lock on the interior power door lock switch
with the driver and/or passenger door open.
○
Push the lock button on the exterior Passive
Entry door handle with a valid key fob available
in the same exterior zone
page 19.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
TO DISARM THE SYSTEM
The Vehicle Security system can be disarmed using any
of the following methods:
•
Push the unlock button on the key fob.
•
Grab the Passive Entry door handle (if equipped)
page 19.
•
Cycle the vehicle ignition system out of the OFF
position.
○
For vehicles equipped with Keyless Enter 'n Go™
— Passive Entry, push the keyless ignition START/
STOP ignition button (requires at least one valid
key fob in the vehicle).
NOTE:
•
The driver's door key cylinder and the liftgate button
on the key fob cannot arm or disarm the Vehicle
Security system.
•
The Vehicle Security system remains armed during
power liftgate entry. Pushing the liftgate button will
not disarm the Vehicle Security system. If someone
enters the vehicle through the opened liftgate, then
opens any door, the alarm will sound.
•
When the Vehicle Security system is armed, the inte-
rior power door lock switches will not unlock the
doors.
The Vehicle Security system is designed to protect your
vehicle. However, you can create conditions where the
system will give you a false alarm. If one of the previ-
ously described arming sequences has occurred, the
Vehicle Security system will arm regardless of whether
you are in the vehicle or not. If you remain in the vehicle
and open a door, the alarm will sound. If this occurs,
disarm the Vehicle Security system.
If the Vehicle Security system is armed and the battery
becomes disconnected, the Vehicle Security system will
remain armed when the battery is reconnected; the
exterior lights will flash, and the horn will sound. If this
occurs, disarm the Vehicle Security system.
REARMING OF THE SYSTEM
If something triggers the alarm and no action is taken
to disarm it, the Vehicle Security system will turn the
horn off after a 29 second cycle (with five seconds
between cycles and up to eight cycles if the trigger
remains active) and then rearm itself.
GETTING TO KNOW YOUR VEHICLE
SECURITY SYSTEM MANUAL
OVERRIDE
The Vehicle Security system will not arm if you lock the
doors using the manual door lock.
DOORS
MANUAL DOOR LOCKS
To lock each door, rotate the door lock knob on each
door trim panel forward. To unlock the front doors, pull
the inside door handle to the first detent or rotate the
door lock button until the ribbing is visible. To unlock
the rear doors, rotate the door lock button until the red
indicator is visible.
Manual Front Door Lock
17
2
Advertisement
Table of Contents
