Center Support Inspection - Suzuki Grand Vitara Manual

5A-122 Automatic Transmission/Transaxle:
• When installing brake discs, brake plates and clutch
backing plate, refer to "Center Support Components:
".
• Install clutch backing plate (1) with its flat side facing
brake disc.
2. Step
• After installing each retaining backing plate ring,
measure movement of brake piston again.
If it is not within standard range, it is possible that ring
is not installed properly. Then disassemble and
reassemble again.
Standard movement of second coast brake piston
and second brake piston
Second coast brake piston: 1.00 – 1.20 mm (0.039
– 0.047 in.)
Second brake piston: 1.01 – 2.25 mm (0.040 –
0.089 in.)

Center Support Inspection

• Check that sliding surface of discs and plate are not
worn or burnt. If necessary, replace them.
NOTE
• If disc lining is exfoliated, discolored or
worn hardly, replace all discs.
• If only a part of printed numbers is
corroded, replace all discs.
• Before assembling new discs, soak them
in A/T fluid for at least 15 minutes.
www.CarGarage.ir
• Measure inside diameter of center support hub
bushing. If inside diameter exceeds limit, replace
center support.
Center support bushing inside diameter standard
36.386 – 36.411 mm (1.4325 – 1.4335 in.)
I5JB0A510122-01
• Measure inside diameter of planetary sun gear
bushing. If inside diameter exceeds limit, replace
planetary sun gear.
Planetary sun gear bushing inside diameter
standard
21.501 – 21.527 mm (0.8465 – 0.8475 in.)
S5JB0A5106089
• Measure free length of piston return spring.
Standard free length of second coast brake piston
return spring
16.84 mm (0.663 in.)
Standard free length of second brake piston
return spring
15.82 mm (0.623 in.)
I4JA01512210-01
www.CarGarage.ir
I5JB0A510123-01
I5JB0A510124-01
I5JB0A510171-01