Removal And Installation; Solenoid Valves; Transmission Fluid Temperature Sensor Removal And Installation - Suzuki Grand Vitara Manual

Operation check
Check pressure control solenoid valves (Pressure
control solenoid and TCC pressure control solenoid) (1)
operation in either of the following methods.
[Using regulated DC power supply]
1) Connect pressure control solenoid valve (1) with
regulated DC power supply (2) as shown in the
figure.
2) Turn regulated DC power supply switch ON,
increase voltage of power supply keeping current
within 1.0 A.
3) Check that valve (3) moves gradually in arrow "A"
direction as voltage increases.
4) Check that valve (3) moves in arrow "B" direction as
voltage decreases.
5) Turn power supply switch OFF.
CAUTION
!
Do not feed current 1.0 A or more, or
pressure control solenoid will be burned out.
[Not using regulated DC power supply]
1) Connect pressure control solenoid valve (1) to
battery (4) setting 21 W bulb (2) in between as
shown in the figure.
2) Check that valve (3) moves in arrow "A" direction.
3) Disconnect pressure control solenoid valve (1) from
battery (4) and check that valve (3) moves in arrow
"B" direction as shown in the figure.
CAUTION
!
Set 21 W bulb in between, or pressure control
solenoid valve will be burned out.
www.CarGarage.ir
Transmission Fluid Temperature Sensor

Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Pull out fluid level gauge and lift up vehicle.
3) Remove drain plug and drain A/T fluid.
4) Install drain plug with new gasket.
I4JA01512033-01 5) Remove oil filler tube (2) and A/T oil pan (1).
6) Remove A/T oil strainer (1).
www.CarGarage.ir
Automatic Transmission/Transaxle:
3
1
5A-93
I4JA01512034-01
S5JB0A5106062
2
1
I5JB0A510051-02
I5JB0A510052-01