Suzuki Grand Vitara Manual page 157

Remounting
For remounting, reverse dismounting procedure.
• Apply grease to input shaft.
"A": Grease 99000–25010 (SUZUKI Super Grease
A)
"A"
• Slant the rear of the engine down, using support
device (1) and install transmission to engine.
• Use specified torques as given below.
Tightening torque
Transmission to engine bolt and nut (a): 85 N·m (
8.5 kgf-m, 61.5 lb-ft)
Engine rear mounting member bolt (b): 55 N·m (
5.5 kgf-m, 40.0 lb-ft)
Clutch housing lower plate bolt (c): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Engine rear mounting No.2 bolt (d): 55 N·m (5.5
kgf-m, 40.0 lb-ft)
• Set each clamp for wiring and hose securely.
• Install shift control lever referring to "Transmission
Shift Control Lever Removal and Installation: ".
• Connect clutch fluid joint to pipe of clutch operating
cylinder assembly referring to "Clutch Operating
Cylinder Assembly Removal and Installation: in
Section 5C".
www.CarGarage.ir
• Install exhaust No.2 pipe referring to "Exhaust System
Components: in Section 1K".
• Fill gear oil to transmission referring to "Manual
Transmission Oil Change: ".
• Fill gear oil to transfer referring to "Transfer Oil
Change: Motor-Shift Type (Transfer with Shift
Actuator) in Section 3C" or "Transfer Oil Change:
Non-Shift Type (Transfer without Shift Actuator) in
Section 3C".
• Connect battery and check function of engine, clutch,
transmission and transfer.
• Install propeller shafts referring to "Propeller Shaft
Removal and Installation: in Section 3D".
I5JB0A520031-01
(b)
I3JA01520024-01
(c)
www.CarGarage.ir
Manual Transmission/Transaxle:
(d)
(a)
(c)
(a)
5B-16
(b)
(a)
I5JB0A520032-01