Suzuki Grand Vitara Manual page 137

38) Apply A/T fluid to new O-ring and spring and install
them to accumulator piston and install accumulator
piston to transmission case.
Accumulator spring specification
Accumulator
Spring free
piston
length "a"
Forward clutch
Direct clutch
Second brake
2
1
1. Forward clutch accumulator piston
2. Direct clutch accumulator piston
3. Second brake accumulator piston
4. Accumulator spring
39) After confirming that accumulator piston is pushed all
the way down, match pin of manual shift lever with
groove in manual valve.
www.CarGarage.ir
Accumulator spring
Color
75.03 White + Blue
57.74 White + Purple
56.16 Purple
"a"
3
4
I5JB0A510140-01
IYSQ01510269-01
www.CarGarage.ir
Automatic Transmission/Transaxle:
40) Fix valve body (1) by using bolts with each nominal
length as indicated in the figure and tightening to
specified torque.
Tightening torque
Valve body bolt: 10 N·m (1.0 kgf-m, 7.5 lb-ft)
Valve body bolt nominal length
"a": 28 mm (1.10 in.)
"b": 30 mm (1.18 in.)
"c": 36 mm (1.42 in.)
"d": 45 mm (1.77 in.)
"a"
"c"
"d"
"c"
"a"
41) Install O/D brake applying tube (1).
42) Lubricate new O-ring with A/T fluid and attach it to
grommet of solenoid wire harness. Then connect
solenoid wire harness to transmission case and fix it
with solenoid wire harness clamp. Connect each
connector to solenoid. And install new gasket and
brake applying cover.
Tightening torque
Transmission wire connector bolt (a): 16 N·m (
1.6 kgf-m, 11.5 lb-ft)
5A-133
1
"b"
"d"
"c"
"d" "b" "a" "d"
I5JB0A510141-01
1
I5JB0A510143-02
(a)
I5JB0A510142-01