Dtc P0717 Input / Turbine Speed Sensor Circuit No Signal - Suzuki Grand Vitara Manual

5A-52 Automatic Transmission/Transaxle:

DTC P0717 Input / Turbine Speed Sensor Circuit No Signal

Wiring Diagram
1. TCM
2. Input shaft speed sensor
DTC Detecting Condition and Trouble Area
DTC Detecting Condition
No pulse signal of input shaft speed sensor is inputted for 5
pulses period of output shaft speed sensor through it is
detected more than 600 rpm.
(1 driving cycle detection logic)
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine and shift select lever to "D" range.
4) Start vehicle and increase vehicle speed to about 40 km/h (25 mile/h) for 3 minutes or more.
5) Stop vehicle.
6) Check DTC, pending DTC and freeze-frame data.
DTC Troubleshooting
Step
1 Was "A/T System Check" performed?
2 Check input shaft speed sensor circuit
1) Disconnect TCM connectors with ignition switch OFF.
2) Check for proper connection to input shaft speed sensor
at "E93-6" and "E93-16" terminals.
3) If OK, check resistance of sensor circuit.
Resistance of input shaft speed sensor circuit
Between terminals "E93-6" and "E93-16" of
disconnected harness side TCM connector: 560 –
680 Ω at 20 °C (68 °F)
Between terminals "E93-16" of disconnected
harness side TCM connector and ground: No
continuity
Are check results satisfactory?
www.CarGarage.ir
2
BLU
PNK
E92
6 5 4 3 2 1
16 15 14 13 12 11 10 9 8 7
24 23 22 21 20 19 18 17
3. Terminal arrangement of TCM connector (viewed from harness side)
Action
www.CarGarage.ir
E93-6
E93-16
2.5V
E93
6 5 4 3 2 1
17 16 15 14 13 12 11 10 9 8 7
21 20 19 18
26 25 24 23 22
• Input shaft speed sensor or its circuit malfunction.
• Improper input shaft speed sensor installation.
• Damaged clutch drum.
• Foreign material attachment to sensor or drum.
• TCM
Yes
Go to Step 2.
Go to Step 4.
S5JB0A5104031
1
3
I5JB0A510022-01
Trouble Area
No
Go to "A/T System
Check: ".
Go to Step 3.