Overdrive (Planetary Gear Side) Inspection - Suzuki Grand Vitara Manual

5A-108 Automatic Transmission/Transaxle:
Assembly
Assemble each component by reversing removal
procedure and noting the following points.
• When installing thrust washer (1), bring its oil groove
(3) to the front.
• When installing one-way clutch to one-way clutch
outer race, bring its flange (2) to the front.
[A]: Front
• Before installing piston inner O-ring and piston outer
O-ring, apply A/T fluid to them.
• Install so that snap opening and projection (1) of
clutch piston return spring will not match.
2. Slot
• Install retaining clutch ring and retaining brake hub so
that their slots (2) will not match with dent (1) in O/D
clutch cylinder.
www.CarGarage.ir
• For installing cushion clutch plate (1), refer to the
figure.
2. Clutch cylinder side
3. Brake hub side

Overdrive (Planetary Gear Side) Inspection

• Check that sliding surface of discs and plate are not
worn or burnt. if necessary, replace them.
I5JB0A510154-02
NOTE
• If disc lining is exfoliated, discolored or
worn hardly, replace all discs.
• If only a part of printed numbers is
corroded, replace all discs.
• Before assembling new discs, soak them
in A/T fluid for at least 15 minutes.
IYSQ01510129-01
• Check that ball valve of clutch piston is not stuck.
• Check valve for leakage by applying low pressure air
into ball valve hale.
IYSQ01510130-01
www.CarGarage.ir
IYSQ01510131-01
S5JB0A5106073
I4JA01512210-01
IYSQ01510132-01