Suzuki Grand Vitara Manual page 138

5A-134 Automatic Transmission/Transaxle:
43) Connect solenoid coupler to each solenoid.
44) Install oil strainer (1) to valve body assembly.
Tightening torque
Oil strainer bolt (a): 5.5 N·m (0.55 kgf-m, 4.0 lb-
ft)
1
(a)
45) Install transmission oil pan (1) with new oil pan
gasket.
NOTE
Align cutout in oil pan gasket with that in
transmission case.
Tightening torque
Transmission oil pan bolt: 4.5 N·m (0.45 kgf-m,
3.5 lb-ft)
46) With wood rough key attached to output shaft, install
sensor rotor (2) by aligning its key groove with wood
rough key and install C-ring.
1
2
1. C-ring
www.CarGarage.ir
47) Install adapter case (1) with new adapter gasket to
transmission case and tighten adapter case bolts to
specified torque.
Tightening torque
Adapter case bolt (a): 31 N·m (3.1 kgf-m, 30.0 lb-
ft)
I5JB0A510144-01
48) Apply A/T fluid to new O-rings and install them to
input shaft speed sensor (1) and output shaft speed
sensor (2), and then install input shaft speed sensor
(1) and output shaft speed sensor (2).
49) After turning manual shift shaft fully rearward, turn it
back by 2 notches and set it to "N" range. Then
install shift switch, lock washer and nut and tighten
nut. After tightening it, bend claws of lock washer.
Tightening torque
IYSQ01510094-01
Manual shift shaft nut (a): 12.5 N·m (1.25 kgf-m,
9.0 lb-ft)
50) With neutral reference line (1) and cut groove (2) in
switch aligned, tighten lock bolt.
Tightening torque
Transmission range sensor bolt (b): 5.3 N·m (
0.53 kgf-m, 4.0 lb-ft)
I5JB0A510072-01
www.CarGarage.ir
(a)
1
(b)
(a)
1
(a)
I5JB0A510145-01
2
I5JB0A510163-01
1
2
I5JB0A510147-01