Call Channel Operation; I Call Channel Transferring; I Call Channel Selection - Icom IC-V8000 Instruction Manual

7

CALL CHANNEL OPERATION

I Call channel selection

1
2
3
4
5
Push [M/CALL(PRIO)] several
6
times to select the call channel.
7
8
9
10
11
Appears
12
➥ Push [MR/CALL] for 1 sec. to select the call
13
MR/CALL channel.
14
• Push [
[VFO/LOCK] to select VFO mode.
15
16
17
✔INFORMATION
18
19
20
21
Small "C" shows VFO was
selected from the call channel.
35
➥ Push [M/CALL(PRIO)] sev-
eral times to select the call
channel.
• "C" appears instead of mem-
ory channel number indication.
• Push [M/CALL(PRIO)] once or
twice to select memory mode,
or push [V/MHz(SCAN)] to se-
lect VFO mode.
] to select memory mode, or push
MR/CALL
When the VFO mode is se-
lected from the call channel,
small "c" appears instead of
memory channel number.

I Call channel transferring

q Push [M/CALL(PRIO)] several times to select the call
channel.
• Large "C" appears.
w Push [MW(S.MW)] momentarily, then rotate the tuning dial
to select the memory channel to transfer the contents to.
• To transfer to the VFO, push [MW(S.MW)] for 1 sec.
e Push [MW(S.MW)] for 1 sec. to transfer when a momen-
tary push was used in the previous step.
• If channel names have been programmed into the call channel,
the names also transferred.
z Push [MR/CALL] for 1 sec. to select the call
MR/CALL
channel.
x Push [FUNC], [
push [Y]/[Z] to select the memory channel to
MW
transfer the contents to.
• To transfer to the VFO, push [FUNC], then push
[ A(MW)] for 1 sec.
CLR
[Y]/[Z]
c Push [FUNC], then [
transfer when a momentary push was used in
the previous step.
v Push [MR/CALL] for 1 sec. to select the call
channel.
• If channel names have been programmed into the
call channel, the names also transferred.
A(MW)] momentarily, then
CLR
A(MW)] for 1 sec. to
CLR